12V 60W Electric Fuel Transfer Pump Kit - Universal Car Oil Extractor & Fluid Exchange Pump for Gas, Diesel, ATF - Perfect for Automotive Maintenance, Marine & Industrial Use

Product Description

Specifications: Rated Voltage: DC 12V Rated Power: 60W Maximum Pressure: Max. 0.8MPA Maximum Flow: 5L/min Pump Diameter: Approx. 4.8cm / 1.89" Length: Approx. 14.5cm / 5.7" Outlet Pipe Size(Dia.*L): Approx. 11mm*140cm / 0.43" * 55" Inlet Pipe Diameter: Approx. 8mm & 6 mm / 0.31" & 0.24" Inlet Pipe Length: Approx. 100cm / 39.37" Cable Length: Approx. 30cm / 11.8" Clips Length: Approx. 8cm / 3.15" Main Color: Black How to use: 1. Start to run the car engine for a while, when oil temperature tu to be about 50 degrees, start pumping oil. 2. Connect the pump to the power, run it for a while, and observe whether the inlet and outlet is normal. 3. Open the filler cap,get dipstick out, force the tube into the bottom of the joint, until the tube does not move; then put the inlet pipe from the oil dipstick into in end(the tube into the bottom of the tank, the bottom concave place, in order to pump the oil completely). 4. After oil pumping, remove the tube, and then run the pump for a while, pump the remaining oil inside the pumping clean, or pump water for a while until the pump head gets clean. 5. If you have not used it for a long time, it may have no suction, then just pour the water in the pump, and run the pump for a few minutes until the air is all out. Package Inculded: 1 x oil pump 1 x 11mm outlet pipe 1 x 8mm inlet pipe 1 x 6mm inlet pipe 2 x clips Note: 1. Please allow 1-3mm error due to manual measurement. Thanks for your understanding. 2. If you want to connect this pump to AC power, you will need a power converter. 3. please use when the engine is warm, the engine oil is warm and viscosity is lower, this will be easier and faster to pump. 4. This product is not allowed to pump corrosive liquids, strong acids and strong alkaline liquids.